Fujitsu PRIMERGY RX900 S2 - Removing the Expansion Card from the Slot; Inserting the Expansion Card in the Slot

RX900 S2 Upgrade and Maintenance Manual 161
Expansion cards and BBU
8.9.4 Removing the expansion card from the slot
Figure 91: Removing the expansion card from the slot
Ê If applicable, remove the cables from the expansion card.Remove the slot
lock by pulling the green handle upward (1), pushing the plastic part down
(2), and lifting the slot lock (3).
Ê Carefully pull the expansion card out of the lot (4).
8.9.5 Inserting the expansion card in the slot
Figure 92: Inserting the expansion card in the slot
2
/
0
1
1
/
0