42 Upgrade and Maintenance Manual RX900 S2
Basic procedures
© cognitas. Gesellschft für Technik-Dokumentation mbH 2011 Pfad: C:\Programme\FCT\tim_app\tim_local\work\WALTER\OBJ_DOKU-12046-001.fm
4.4 Sliding the server out of the rack
V CAUTION!
● Use the anti-tilt plate to prevent the rack from tipping when installing
the rack. Pulling the server out of the rack without having installed the
anti-tilt plate may cause the rack to tip over.
● Be careful not to pinch fingers or clothes when sliding out the server
or pushing it back. Failure to do so may cause injury.
● Follow the safety instructions in the chapter "Safety instructions" on
page 31.
Figure 4: Removing the server
Ê Loosen the knurled screws (see circle).
Trained personnel
1
0
To Next Page
Loading...
