Fujitsu PRIMERGY RX900 S2 - Installing a Dummy Module; Completing the Task

RX900 S2 Upgrade and Maintenance Manual 61
Power supply
5.3.4 Installing a dummy module
I Dummy modules protect free bays against environmental impact.
Figure 17: Installing a dummy module in a PSU bay
Ê Press the two plastic clips together as indicated by the arrows and install the
dummy module.
5.3.5 Completing the task
Ê Perform the following procedures to complete the task:
1. Close the rear door of the rack, see "Closing the rack door" on page 51