GRAPHTEC CE8000 Series - Positioning of the Media and the Registration Mark; Cutting Area When Adjusting the Registration Mark

5-6
Positioning of the Media and the Registration Mark
Place the registration mark away from the edge of media to scan the registration mark.
Make sure the push roller location is outside of the registration mark.
Draw the registration mark as shown in the next image.
MARK TYPE 2MARK TYPE 1
15* 35
17 37
Rightmost
push roller
Rightmost
push roller
Leftmost
push roller
Leftmost
push roller
Unit: mm
* When the expand limit is set to 1 or more, it will be 10.
Cutting area (same as the area after scanning the registration mark)
15 1515 15
Feed direction of media Feed direction of media
Cutting area when adjusting the registration mark
Even when the registration marks are being adjusted, you can cut the outside of the registration mark (cutting area).
Media
Cutting area (same as the area after scanning the registration mark)
MARK TYPE 1
MARK TYPE 3
MARK TYPE 2
MARK TYPE 4
Origin point
Origin point Origin point
Origin point
Feed direction of mediaFeed direction of media Feed direction of mediaFeed direction of media