GRAPHTEC CE8000 Series - Enabling;Disabling the Push Roller Sensors

10-5
6. Press the [ENABLED] or the [DISABLED] for the sensor.
7. Press the [ ] icon.
It will return to HOME screen.
Enabling/Disabling the push roller sensors
Set the push roller sensors that detect the width of the media to "DISABLED".
If you want to enable it, set it to "ENABLED" here.
Usually, please use it while set to “Enabled”.
When set to “Disabled”, the cutting mat may be damaged. Please always set the “Cutting Area”.
CAUTION
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [ ] icon.
4. Press the [SENSOR].
5. Press the [PUSH ROLLER SENSOR].