3-5
Move away the tool carriage
It is possible to move the tool carriage toward upper right.
It makes it easier to confirm the cutting results if you perform this operation after the cutting is completed.
<When using Roll Media>: Seen from above
Position of the pen carriage
before moving away
To the bottom of the cutting
area (machine origin point)
Standby position
of the pen carriage
100mm
<When using Sheet Media>: Seen from above
To the top of the
maximum cutting area
Bottom of the operation
area (machine origin point)
Operation
1.
Press the [ ] icon.
2.
Press the [VIEW].
Tool carriage will move away.
3.
Press the [HOME].
Tool carriage will move to the origin point.
To Next Page
Loading...
