2-34
2.8
Setting Feeding Method
Feeding method for the loaded media is set.
Operation
1.
If you have already loaded the media, the MEDIA TYPE menu appears. Select the media type to suit the
loaded media.
Check that the media stopper is unlocked (CE8000-60/CE8000-130) and then select a media type on the
MEDIA SELECT screen.
* The figure below is CE8000-130.
Release the media stopper
Media stopper
Before doing the media set selection, make sure to release the media lock.
If you raise or lower the media set lever again after loading the media, [Continue] will be added and you can
select the previous setting.
If you use the same media without changing its position, the cutting area, pen position and origin point before
lowering the media set lever will continue. If you reload the media without changing the media width, you can
omit the media width detection operation.
Supplement
[ROLL-1 FRONT EDGE]
Select this when you have loaded a roll media and you wish to start cutting or plotting from the leading
edge.
The width and leading edge of the roll media are detected.
[ROLL-2 CURRENT POSITION]
Select this when you have loaded a roll media and you wish to start cutting or plotting from a point beyond
the leading edge.
Only the width of the roll media is detected.
To Next Page
Loading...
