GRAPHTEC CE8000 Series - Copy (Duplicate Cutting); When Media Change Mode Is off

4-9
4.2 Copy (Duplicate Cutting)
Repeats cutting the specified number of times using the cutting data held in the buffer memory.
•
Do not send new data to plotter while copying. Cutting data in the buffer memory will be cleared.
•
Previous cutting data will be cleared and newly sent data will be stored as cutting data if you send new data with 10
seconds or more interval from the time it finished cutting.
•
It can not copy if data is more than 1.6 MB because it cannot be stored in the buffer memory of the plotter.
•
Buffer memory that can be used for copy will decrease if you turn on the data sort.
Turn off the data sort when you need to copy cutting with large data.
See "8.1 Sorting the Cutting/Plotting Data" for data sort.
•
If the original cutting data to be copied starts away from the origin point, copied cutting will also start away from the
origin point.
To Avoid wasted space, create the cutting data close to the origin point.
•
When copying using a roll paper barcode, be sure to scan the bar code on the leading edge.
Supplement
When media change mode is OFF
Copy is performed in following order.
Origin point
First cut
Copy origin point
First copy
Second copy
Copy space
Copy
space
Fourth copy
Third copy
Copying when setting MIRROR is performed in the following order.
Origin point
First cut
Copy origin point
Second copy
First copy
Copy space
Copy
space
Fourth copy
Third copy