2-4
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a tool
When mounting the tool in the tool holder, please note the following.
•
Never touch the tool when the power is turned on or while it is in operation, as it is dangerous.
•
When handling the tool holder, be careful not to get injured by the cutter blade.
It is explained here using cutter plunger as an example.
•
When using with half cutting and plotter pen, set the seal in Tool Holder (backward), and when using cutting out
(perforated cut), set the seal in Tool Holder (forward).
•
Half cutting means that only the marking film is cut out, leaving the backing sheet uncut.
•
Cutting out means that the media is cut out completely.
•
Structure of Marking film
Marking film
Backing sheet
Supplement
Mounting
1.
Loosen the tool holder screw.
Tool holder
Tool clamper
Tool clamper
Tool holder
Top view
Loosen the screw until
this protrusion comes off.
To Next Page
Loading...
