EasyManua.ls Logo

GRAPHTEC CE8000 Series - Page 34

GRAPHTEC CE8000 Series
260 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2-5
2.
Move the tool clamper so that the hole in the tool clamper is aligned with the hole in the tool holder.
Tool holder
Tool clamper
Top view
3.
While pushing up the tool clamper, set the tool in the tool holder.
Tool clamper
Make sure the tool is set straight into the tool holder.
Supplement

Table of Contents

Related product manuals