GRAPHTEC CE8000 Series - Sorting the Cutting Data

8-2
8.1 Sorting the Cutting Data
When sorting cutting/plotting data, cutting is performed collectively so that the amount of movement in the media
feed direction and the tool replacement time are minimized, so cutting operation is improved efficiently.
This function sorts so that the amount of movement in the media feed direction is minimized, so it is effective for
plotting data where the tool is raised to the cutting position and moves here and there.
•
Sorting will start the process after all the data are stored in the buffer memory, so it takes time to start the cutting.
•
Sorting might not be effective for the data that is created efficiently.
•
Process may be faster to turn off the sorting on the plotter, if the data is already sorted using the software on the PC.
Supplement
Operation
1. Press the [ ] icon.
2. Press the [TOOL].
3. Press [DATA SORTING] to turn it to [ON].
To cancel, set it to [OFF].
4. Press the [ ] icon.
It will return to HOME screen.
When the setting is turned ON, a [ ] mark will be displayed at the top of the screen.
Supplement