GRAPHTEC CE8000 Series - Setting Initial Blade Control Position Adjust

7-16
7.6 Setting Initial Blade Control Position Adjust
After turning on the power or changing pen condition settings, touch the blade to the media and adjust the blade
direction. The Initial Blade Control Position will need to be set in order to make sure the area is not damaged and
that the blade properly makes contact with the media.
Selecting "2mm BELOW" will change the Initial Blade Control Position to 2 mm below the cutting start point (2 mm
from the edge of the point from which the media will be shifted.)
Selecting "Y OUTSIDE" will initialize Initial Blade Direction Setting outside the cutting area.
Selecting "SPECIFIED POSITION" will initialize Initial Blade Direction Setting at the Y direction fixed position that
has been set.
* When media narrower than the set Y position is set, it will be the Y maximum value.
2mm
Push roller
Initial Blade Control
Position Setting Point
(Set as "Y OUTSIDE")
Cut Start Point
(Cutting Origin Point)
Initial Blade Control
Position Setting Point
(Set as "2mm BELOW")
Cutting area
Selecting [Y OUTSIDE] and then changing the expand setting to a positive digit (8 mm ABOVE) can damage the
cutting mat.
CAUTION
Operation
1. Press the [ ] icon.
2. Press the [TOOL].
3. Press the [INITIAL B. ANGLE POSITION].