GRAPHTEC CE8000 Series - Perform Automatic Pre Feed When Cut Data Is Received

8-3
8.2 Perform Automatic Pre Feed When Cut Data is Received
It is possible to feed and reverse the media automatically for specified amount when the plotter receives the cutting
data.
"Pre feeding" to prevent the shifting of media can be done automatically.
Also, the media will be unrolled from the roll before cutting when rolled media is to be used.
•
The setting for AUTO PRE FEED when cutting data is received is maintained even if the power is turned off.
•
Setting of the AUTO PRE FEED length is not linked to the setting of the page length. Change the setting for the page
length if the cutting area is to be long.
•
If data is received and auto media transfer is performed once, even if (cut in the same area) data is received again,
auto media transfer will not take place.
Supplement
Operation
1. Press the [ ] icon.
2. Press the [MEDIA].
3. Press the [AUTO PRE FEED].
4. Press [ENABLE FUNCTION] to turn it to [ON].
To cancel, set it to [OFF].
5. Press the [FEED LENGTH].