2-39
•
Finish will become coarser, but the cut time is decreased when the settings for the speed and acceleration is set
higher.
Especially with the large media, good cut quality might not be achieved by rumbling media. Decrease the values for
the speed and acceleration settings in that case.
•
Finish will become good, but the cut time will increase when the settings for the speed and acceleration is set
smaller.
•
If you try to set speed 64 and acceleration 3 at the same time on CE8000-40/60, the acceleration will be displayed as
" * ".
In this case, the speed and acceleration settings will operate with automatically calculated values.
•
If the acceleration is 2 for CE8000-130, the speed cannot be set to 65 or higher (65, 70, 71).
In this case, the acceleration will be displayed as " * " and the speed and acceleration settings will operate with
automatically calculated values.
Supplement
Setting the tool
Set the type value of the tool that is used.
Operation
1.
Press the [ ] icon.
2.
Press the [EDIT CUT CONDITION].
3.
Press the tool condition number (1 to 8) you want to set.
4.
Press the [TOOL].
To Next Page
Loading...
