3-8
When coordinate axes rotation are set
If the origin point is moved while the coordinate axes are rotated, the origin point will move as shown below.
See "3.4 Setting the Cutting Direction" about the rotation of the coordinate axes.
Supplement
New origin
point
Original origin point
When coordinate axes are rotated after origin point is set
The origin point will be initialized as shown below if the coordinate is rotated after moving the origin point.
Distance "a" will be maintained, but distance "b" will be initialized.
New origin point
Original
origin point
Original
origin point
Before setting After setting
aa
b
New origin
point
•
To use the origin point movement and coordinate axes rotation together, always rotate the coordinate axes first, and
then move the origin point.
•
Coordinate value displayed after setting new origin point is a distance from the new origin point.
Supplement
To Next Page
Loading...
