GRAPHTEC CE8000 Series - Adjusting the Blade Length; Blade Application and Features

2-3
Adjusting the blade length
Blade length needs to be adjusted to perform optimal cut.
Perform few test cuts and set the optimal blade length.
•
To avoid bodily injury, handle cutter blades with care.
•
It may result in damaging the cutter blade or the cutting mat if the blade is extended too much. Make sure the blade
length is set less than the thickness of the media.
After adjustment, please always perform "CUT TEST".
CAUTION
See "2.11 Running Cutting Tests" for cutting tests.
Supplement
Adjust the blade length by turning the blade-length adjustment knob. Turn the knob in direction "A" to extend
the blade, or in direction "B" to retract the blade. When the knob is turned by one scale unit, the blade moves
approximately 0.1 mm. One full turn of the knob moves the blade approximately 0.5 mm.
Cutter blade moves
approximately 0.1 mm
turning one scale unit
Scale
Scale
PHP33-CB09N-HS/PHP33-CB15N-HS
Blade application and features
Select the optimal cutter blade and media to be cut.
Refer to the Cutter Blade Manual.
To avoid bodily injury, handle cutter blades with care.
CAUTION