4-2
4.1
Settings for Cutting
Settings such as area and width of cutting, page length, mirrored, enlarged, shrunk, etc., can be set.
Setting cutting area
Origin point will be set at lower left of the AREA once the AREA is set.
It is possible to set the origin point at the center when the HP-GL is selected.
Move the origin point to change the cutting position.
See "3.3 Setting the Origin Point " for the moving the origin point, and origin point using the HP-GL command.
Supplement
Upper right
set position
Image already cut
Origin
point
It will only cut
within this range
Operation
1.
Press the [ ] icon.
2.
Press the [AREA].
3.
Press the [ ] icon.
To Next Page
Loading...
