10-4
10.2
Related to sensor
This section describes how to make the sensor-related settings.
Enabling/Disabling the media sensors
You can disable the sensors that detect the presence or absence of media and the size of the medium in the feed
direction.
If you want to enable it, set it back to "ENABLED" here.
Normally, please use it while set to "ENABLED". Turn it DISABLED when setting undetectable media with high
transmittance.
When set to "DISABLED", the cutting mat may be damaged. Please be sure to configure the "area".
Operation
1.
Press the [ ] icon.
2.
Press the [CONFIG].
3.
Press the [ ] icon.
4.
Press the [SENSOR].
5.
Press the [MEDIA SENSOR].
To Next Page
Loading...
