2-6
4.
Move the tool clamper.
When using with half cut and pen, push the tool clamper until it touches the backward side firmly.
When using the cutting out (perforated cut), pull the tool clamper until it touches the forward side firmly.
<When using with half cut and pen>
Move using the triangle mark in the
forward side as a guide.
Tool clamper
<When using with the cutting out (perforation cut)>
Move using the triangle mark in the back as a
guide.
Make sure the tool is set straight into the tool holder.
Supplement
5.
Tighten the tool holder screw.
Removing the tool
To remove the tool, loosen the screw until this protrusion mentioned in step 1 of "Attaching a tool" comes off and
then remove the tool.
To Next Page
Loading...
