2-21
Mounting the Carrier Sheet Table
1.
Mount the carrier sheet table to the front and back of the cutting plotter.
Insert the projection under the carrier sheet table into the dent part.
For CE8000-40, insert the front side into the first and third grooves from the right. Align the back side in the
same position as the front side.
For CE8000-60, insert the front side into the second and fourth grooves from the right. Align the back side
in the same position as the front side.
* The carrier sheet table (OPH-A45) is an optional item.
Carrier Sheet Table Carrier Sheet Table
Setting method of carrier sheet (Carrier Sheet Table)
1.
When setting the carrier sheet, insert it so that the narrowest margin (transparent part) of the carrier sheet is
at the top, and make sure that the carrier sheet is in front of the cutting plotter as shown in the figure.
Make sure that the carrier sheet does not come out behind the cutting plotter.
GOOD
NG
Carrier Sheet Carrier Sheet
Set it so that the right edge of the carrier sheet aligns with the guidelines on the front guide.
Guideline
Line up
The edge of the carrier sheet
is aligned with the guideline.
2.
When the set lever is raised, the push roller lowers and the carrier sheet is fixed.
To Next Page
Loading...
