GRAPHTEC CE8000 Series - Moving the Pen While Raised or Lowered in Response to the W Command

11- 6
Moving the pen while raised or lowered in Response to the 'W' command
Here, you can change the settings for the 'W' command, which is a GP-GL arc cutting command.
The pen will move to the specified starting position in the raised status when it is set to TOOL UP, regardless of the
pen’s conditions.
The pen will move without changing its condition, to the specified starting position in the lowered status when it is
set to TOOL DOWN.
This has an effect on the tool cutter only. For the pen setting, always the pen is raised (PEN UP).
Supplement
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [COMMAND].
4. Press the [ ] icon twice.
5. Press the [COMMAND 'W'].
6. Press the setting value you want to use.
7. Press the [ ] icon.
It will return to HOME screen.