2-26
2.6
Connecting to the Power
Turning on the power of the plotter.
Operation
1.
Check that the power switch is turned off. (the " " side is pressed down)
2.
Connect one end of the provided power cord to the CE8000 AC line inlet and the other end to an electrical
socket of the rated supply voltage.
3.
Turn on the CE8000 by pressing the "|" side of the switch. LCD on the control panel is lit.
When turning the power off, wait over 20 seconds before turning it on again, otherwise problems may occur
with the display.
Supplement
4.
If media has not been loaded, the firmware version number is displayed, followed by a prompt to load
media.
Media set lever raised
(The push roller is up)
Media set lever lowered
(The push roller is down)
The Default Screen will appear after purchasing the machine. See "2.5 About the Default Screen" for more
information.
Supplement
To Next Page
Loading...
