GRAPHTEC CE8000 Series - Plotter Environment-Related Settings; Fan Suction Setting

10-7
10.3 Plotter Environment-related Settings
This section describes how to make the plotter environment-related settings.
Fan suction setting
This function sets the suction force used to affix media to the plotter.
It may not feed properly if the media is thin, so set to "WEAK".
Operation
1. Press the [ ] icon.
2. Press the [CONFIG].
3. Press the [GENERAL].
4. Press the [ ] icon twice.
5. Press the [FAN POWER].
6. Press the setting value you want to use.
7. Press the [ ] icon.
It will return to HOME screen.