GRAPHTEC CE8000 Series - Replacing Cutter Blade

14-3
14.2 Replacing Cutter Blade
Replace the cutter blade by referring to the structure diagram of the cutter plunger.
To avoid bodily injury, handle cutter blades with care.
CAUTION
PHP33-CB09N-HS/PHP33-CB15N-HS
Cutter blade
φ 0.9mm / φ1.5mm
Plunger
Plunger-cap
Blade-length adjustment knob
Hole
Color ring
PHP33-CB09N-HS: Blue
PHP33-CB15N-HS: Red
Operation
1. Turn the blade-length adjustment knob in the direction of the B arrow and pull the blade into the plunger.
One scale unit
approximately 0.1 mm
Scale
Scale
PHP33-CB09N-HS/PHP33-CB15N-HS
2. Turn the plunger cap in the counter-clockwise direction to remove it from the plunger.
3. Remove the blade from inside the plunger cap.
4. Take a new blade out of its pack. Insert the new blade into the hole provided in the plunger cap.
5. Insert the blade into the plunger cap and attach the plunger from above in that state.
6. Secure the plunger cap by turning it clockwise.
Please fully insert the cutter blade straight into the plunger cap.
If the cutter blade cannot be inserted straight, please insert the cutter blade after pressing the insertion port of
the cutter blade several times.
If not installed correctly, it may result in damage to the cutter blade or the plotter itself.
Insertion port of the cutter blade
CAUTION