GRAPHTEC CE8000 Series - Set the Registration Mark Automatic Detection

5-19
Set the registration mark automatic detection
When setting the registration mark automatic detection to on, if the current position of the tool is close to the
position of the first registration mark (Point 1) at the time of registration mark automatic detection, the registration
mark is automatically scanned without moving to the scanning start position of tool. f set to OFF, this operation will
not be performed.
If the current position of the tool is distanced from the first registration mark, detection may take a long time, and errors
due to not finding anything may occur.
Supplement
Operation
1. Press the [ ] icon
2. Press the [ARMS].
3. Press [MARK AUTO SCAN] to turn it to [ON].
To cancel, set it to [OFF].
4. Press the [ ] icon.
It will return to HOME screen.