GRAPHTEC CE8000 Series - Printing the Setting of the Plotter

15-17
15.3 Printing the Setting of the Plotter
Condition setting list can be printed when you need to check the current setting of the plotter.
Operation
1. Load a media larger than A3 size.
2. Set the pen tool to the tool holder (Backward) and select the condition where the pen tool is set.
3. Press the [ ] icon.
4. Press the [INFO].
5. Press the [CONDITION LIST].
6. Press the [1/2 PAGE] or [2/2 PAGE].
7. Press the POSITION ( , , , ) key to move the tool to the print start position.
8. Press the [ENTER] key.
Do not place you hand around the moving areas. The tool carriage will start moving, so there is a chance of
injury.
CAUTION
9. Printing of the condition list will start.