7-13
7.5
Setting Cut Line Pattern
To prevent cut media from falling off while you work, you can change the cutting line to the perforated lines.
There are 8 different patterns of perforated lines set as 0 to 7, and the ratio of cut and uncut part differs in each.
The uncut part becomes shorter with smaller value, making it easier to separate the cut parts.
Every time the machine cuts 8 mm, the tool will be raised by the following length or the FORCE (cutting pressure)
will be reduced to avoid cutting.
• Pattern 0: 0.15 mm • Pattern 1: 0.20 mm • Pattern 2: 0.25 mm • Pattern 3: 0.30 mm
• Pattern 4: 0.35 mm • Pattern 5: 0.40 mm • Pattern 6: 0.45 mm • Pattern 7: 0.50 mm
In addition to above 8 patterns, "OFF" which cuts by the solid line without perforation patter and "USER" where user
can specify a unique pattern are provided.
The processing in the part is not cut with perforation patter is adjusted in "GAP ACTION ".
The perforation patter can be set for each condition number.
•
Normally use it with default value OFF. It will cut with solid line.
•
Use Tool Holder (forward) when cutting with any perforation pattern (aside from turning it off).
See "2.2 Attaching a Tool" for detailed usage instructions.
•
Doing a cut-out (cutting out) with a perforated pattern instead of a normal film cut (half cutting) can damage the
cutting mat and the quality of a normal cut. Please make sure to use Tool Holder (backward).
•
Replacing a cutting mat that was damaged by doing a perforated cut with use of Tool Holder (backward) will require
a service fee.
•
When the tool number is switched between the Tool No. 1 and the Tool No. 3 using the command from the computer,
the following message will appear.
Please follow the message's instructions.
•
The cut on the perforation pattern is shortened by 5 mm on the +X side (back of the media).
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [EDIT CUT CONDITION].
To Next Page
Loading...
