2-51
Adjust the blade length (Automatic Height Adjust)
Test cutting must be performed several times in order to confirm the optimal blade length setting. However, if the
blade length adjustment function is used, the optimal length can be easily set.
The measured height is a guideline only. After attempting to cut the actual media, please adjust blade length
accurately.
For more accurate adjustment, please use a Loupe (PM-CT-001: option).
Supplement
Operation
1.
Load the media for test cutting in the plotter.
2.
Press the POSITION ( , , , ) keys to move the tool carriage to the location you wish to perform the
blade length adjustment.
3.
Press the [ ] icon on the HOME screen.
4.
Press the [BLADE ADJUST].
5.
As instructed, turn the blade length adjustment knob to the left to fully retract the blade.
Blade
See "2.1 Preparation of Cutter Plunger" for blade length adjustment knob.
Supplement
6.
Set the cutter plunger in backward of Tool Holder.
Adjustment is only possible for the cutter pen set in backward of Tool Holder.
It does not apply to forward of Tool Holder.
Supplement
To Next Page
Loading...
