2-27
2.7
How to Use Control Panel
This section explains the function on the control panel.
Screen (LCD touch panel) SLOW key
POSITION ( , , , ) key
ESCAPE key ENTER key
Operation key
POSITION ( , , , ) key .....Adjusts various settings, selects numerical value changes, moves the cursor, and
changes the positions in the MENU screen.
SLOW key..................................When pressing the POSITION key at the same time, the tool carriage moves
slowly.
When the [SLOW] key is pressed in the READY screen, the current cutting/
plotting area and the position of tool carriage are displayed.
If you want to change the cutting conditions while plotting/cutting, press the
[SLOW] key while plotting/cutting.
ESCAPE key ..............................Cancels the setting change and then returns to the previous screen. Returns to
the previous screen in the MENU screen.
If you want to temporarily stop plotting/cutting, press the [ESCAPE] key during
plotting/cutting.
ENTER key ................................Saves the settings, and then returns to the setting screen in various function or
CONDITION setting screen of the MENU screen.
To Next Page
Loading...
