GRAPHTEC CE8000 Series - Adjust Using Plotted Adjustment Registration Mark

5-16
14. Specify the setting value using the [ ] [ ] icon or the [ ] icon.
Enter the value of X measured in step 12.
You can set the range between -3.0 mm and +3.0 mm.
Supplement
15. Confirm the setting and press the [OK].
16. Press the [CORRECTION VALUE Y].
17. Specify the setting value using the [ ] [ ] icon or the [ ] icon.
Enter the value of Y measured in step 12.
You can set the range between -3.0 mm and +3.0 mm.
Supplement
18. Confirm the setting and press the [OK].
19. Press the [SAVE].
20. Press the [ ] icon.
It will return to HOME screen.
Adjust using plotted adjustment registration mark
This section explains the procedure when the registration marks required to adjust the registration mark scanning
position is already plotted on the media.
See “Adjust after plotting the correction registration mark” if there is no registration mark.
Supplement
Operation
1. Load the media with registration marks for adjustment.
2. Press the [ ] icon.