5-15
7.
Press the POSITION ( , , , ) keys and move the tool to the position to create the registration mark
(position nothing is printed)
8.
Press the [ENTER] key.
An adjustment registration mark is created, and then it will return to the SENSOR OFFSET ADJ. screen.
9.
Press the [SCAN].
10.
Press the POSITION ( , , , ) keys to move the tool to the scanning start position.
Feed direction of media
Align the tool to this area
11.
Check the position of the tool and press the [ENTER] key.
After scanning the registration marks, plot the registration marks for comparison. When plotting is
completed, it will return to the SENSOR OFFSET ADJ. screen.
Feed direction of media
Distance adjustment value Y
Distance
adjustment
value X
Registration mark
for adjustment
Registration mark
for comparison
12.
Using the registration mark plotted in step 8, measure the distance of how much the adjustment registration
mark needs to be moved so both will overlap, and record the value. As an example, in the figure in step 11,
it needs to move in negative directions for both X and Y directions, so both of the adjustment values will be
negative values.
Position of the registration mark is measured at the center of the line.
Supplement
13.
Press the [CORRECTION VALUE X].
To Next Page
Loading...
