GRAPHTEC CE8000 Series - Running Cutting Tests; Cutting Test; To Make 1 Cut with Set Value

2-47
2.11 Running Cutting Tests
Test cutting can be performed after making the tool, speed, force, and acceleration settings to ensure that the
selected cutting conditions actually produce the desired cutting results. Check how far the blade cuts into the
media and how the corners are being cut. If the cutting results are not satisfactory, adjust the various settings and
repeat the test cutting until the optimal settings are achieved.
Cutting test
Here, you can either cut one test pattern based on the current values, or do three tests with ±1 values added.
Select the method that suits your situation and make a cutting test.
To make 1 cut with set value
Operation
1. Load the actual media you want to cut.
2. Press the [ ] icon.
3. Press the [CUT TEST].
4. Press the [CUT TEST].
5. Press the POSITION ( , , , ) keys to move the tool carriage to the location you wish to perform the
test
Pressing the POSITION and [SLOW] keys at the same time will move the tool carriage slower.
Supplement