1-8
Front view: CE8000-130
Cutting mat
Grit roller position guide
Cutting groove
Tool carriage
Tool holder
Control panel
Media set lever
Push rollers
Media sensor
Grit rollers
Media stopper
Control panel .............................Used to access various plotter functions.
Media set lever ..........................Used to raise or lower the push rollers during the loading or unloading of media.
Tool carriage ..............................Moves the cutter-pen or plotting pen across the media during cutting or plotting.
Tool holder .................................Holds the cutter-pen or plotting pen and moves it up or down.
Media sensor .............................Used to scan the leading edge of the media.
Push rollers ...............................Rollers that push the media against the grit rollers.
Media stopper ............................This stops the stock shaft from spinning when setting roll paper (media). It is
utilized when pulling roll media straight out.
Grit roller position guide ............A roller position guide is affixed to the front side of the rail, which shows the
position of each grit roller. Use these alignment marks as an aid in locating the
push rollers.
Grit rollers ..................................Feeds the media back and forth.
Cutting mat ................................The cutter blade moves on this cutting mat.
Cutting groove ...........................Use this groove to cut out (die cut) or cross cut.
To Next Page
Loading...
