7-11
7.4
Setting the Distance Adjust
DISTANCE ADJUST value corrects any deviation in the length of cut or plotted line segments, which occurs
depending on the media being used.
DISTANCE ADJUST value for the deviation is specified as a percentage of the total distance. For example, a
setting of +0.05% adjusts a distance of 2 m (2,000 mm) by 2,000 x 0.05% = 1 mm, making 2,001 mm. DISTANCE
ADJUST can be specified for each CONDITION No.
This setting will be saved even if the power is shut off.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [EDIT CUT CONDITION].
3.
Press the [ ] icon three times.
4.
Press the tool condition number (1 to 8) you want to set.
5.
Press the [DISTANCE ADJUST].
6.
Press the [ENABLE FUNCTION] to turn it to [ON].
To cancel, set it to [OFF].
To Next Page
Loading...
