7-18
7.7
Setting the blade control force
Slight cut operation is performed before the actual cut operation to align the blade toward the cutting direction.
Lower FORCE is necessary compared with the normal cutting, so it is possible to set lower FORCE as a BLADE
CTRL FORCE.
BLADE CTRL FORCE is used to control the rotation of the blade with the tangential mode in addition to control the
blade direction at the beginning of the cut.
Operation
1.
Press the [ ] icon.
2.
Press the [EDIT CUT CONDITION].
3.
Press the [ ] icon four times.
4.
Press the tool condition number (1 to 8) you want to set.
5.
Press the [BLADE CTRL FORCE].
6.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
You can set the range between 1 and 38.
Supplement
To Next Page
Loading...
