7-9
7.3
Setting the Offset Angle
The CE8000 analyzes the cutting data, and controls the angle of the cutter blade tip if the change in the angles of
the corner is large.
Angle control is applied if there is larger angle change than the angle specified as reference angle.
The time to cut is shortened by setting large value for the OFFSET ANGLE, since it will only apply blade control
when there are angles with large angle change, hence this saves time and reduces the overall cutting time. But, if
it is set too large, there will be not enough angle control of the blade, and the cut result may differ from what was
expected. Set the reference angle in good balance.
The setting will be saved even if the power is shut off.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [CONFIG].
3.
Press the [ ] icon.
4.
Press the [CUT QUALITY].
5.
Press the [OFFSET ANGLE].
To Next Page
Loading...
