3 -11
3.5
Stop Cutting
It will stop cutting during operation.
The menu is displayed on the screen of the control panel while it is stopped. It is possible to choose either to
continue or stop the operation.
It is also possible to exchange or reset the media while it is stopped.
Pause and resume cutting
Operation
1.
Press the [STOP] or [ESCAPE] key.
2.
Perform necessary operation, such as exchanging the media.
There is no effect on the selection of media type when the media set lever is moved up and down while
pausing the cutting. It is also possible to exchange or reset the media.
Supplement
3.
Press the [RESUME JOB].
Press the [CANCEL JOB] to cancel the cutting.
Supplement
To Next Page
Loading...
