2-23
When feeding long media (2 meters or less)
Position the push rollers at least 5 mm inside the edges of the media.
Push roller
Media
5mm 5mm
When narrow media is used
Make sure that all push rollers are on the long right grit roller. Use the left side of the grit roller as a starting point
and then set the push rollers so that they're on both sides of the media.
The width of media that can be set is 50 mm or more for CE8000-40/60 and 85 mm or more for CE8000-130.
* For CE8000-130, when setting all push rollers to the rightmost grit roller (wide), set the hold-down force of the center push
roller to Low (OFF).
Media sensor
Media
Grit roller
CE8000-40/60
Push roller
Media sensor
Media
Grit roller
CE8000-130
Push roller
•
The media must be at least 125 mm in length in media feed direction.
•
The media must always be positioned over the media sensor.
To Next Page
Loading...
