8-6
8.4
Setting the Moving Speed
Moving speed is the speed the tool moves when it is raised (tool up state).
The cutting time in total becomes short if you set the MOVING SPEED to fast speed even though the speed of the
tool when it is cutting (lowered) is set to slow speed for the hard to cut media (hard or sticky).
This setting will be saved even if the power is shut off.
Supplement
Operation
1.
Press the [ ] icon.
2.
Press the [CONFIG].
3.
Press the [ ] icon.
4.
Press the [EFFICIENCY].
5.
Press the [MOVING SPEED].
6.
Use the [ ] and [ ] icons to display the [MOVING SPEED] to be used.
•
You can set to AUTO, 10 cm/s, 20 cm/s, 30 cm/s, 40 cm/s, 50 cm/s or 60 cm/s.
•
It will be same speed as tool is lowered when AUTO is selected.
Supplement
To Next Page
Loading...
