GRAPHTEC CE8000 Series - Setting the Tangential Mode

7-3
Setting the tangential mode
Enabled (Mode 1 and Mode 2) and OFF of the tangential mode can be set individually for each of tool condition
No. 1 to 8.
Operation
1. Press the [ ] icon.
2. Press the [EDIT CUT CONDITION].
3. Press the [ ] icon four times.
4. Press the tool condition number (1 to 8) you want to set.
5. Press the [TANGENTIAL MODE].
6. Press the mode you want to use.
7. Press the [ ] icon.
It will return to HOME screen.