5-20
Set speed of the registration mark scan
Speed of the tool carriage and media to scan the registration mark is set.
It may not scan the registration marks or the difference may become large when the speed is too high, but the
scanning time becomes longer when the speed is too slow. Adjust the setting value considering the balance.
If the registration mark cannot be scanned or the error is large, setting a low (slower) value may improve the
scanning.
Operation
1.
Press the [ ] icon.
2.
Press the [ARMS].
3.
Press the [ ] icon.
4.
Press the [SENSING SPEED].
5.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
You can set the range between 1 cm/s and 30 cm/s.
Supplement
6.
Confirm the setting and press the [OK].
7.
Press the [ ] icon.
It will return to HOME screen.
To Next Page
Loading...
