GRAPHTEC CE8000 Series - Test the Registration Mark Sensor

5-12
Test the registration mark sensor
If there still is a difference in the cutting/plotting, even after performing an adjustment using the registration mark, it
is possible to check if there is a problem with the registration mark itself or the application by checking the position
of the registration mark plotted.
Operation
1. Print the standard registration mark.
(Either MARK TYPE 1 or MARK TYPE 2 can be used.)
MARK TYPE 1 MARK TYPE 2
•
If you want to test the MARK SCAN MODE 1, print "Test Pattern 1", and if you want to test the MARK SCAN
MODE 2, print "Test Pattern 2".
•
Please download standard registration mark patterns from our website.
Registration Mark Pattern File Format File Name
MARK TYPE 1
pdf ARMStest_type1.pdf
eps ARMStest_type1.eps
MARK TYPE 2
pdf ARMStest_type2.pdf
eps ARMStest_type2.eps
Supplement
2. Load the printed media on the plotter.
3. Press the [ ] icon.
4. Press the [ARMS].
5. Press the [SENSOR ADJUSTMENT].