5-13
6.
Press the [TEST ARMS SENSOR].
7.
Press the type of registration mark you want to use.
8.
Press the POSITION ( , , , ) key to move the tool to the registration mark scanning start area.
Registration mark scanning start area
Feed direction of media
MARK TYPE 1 MARK TYPE 2
Feed direction of media
Move the tool
inside this area
Move the tool
inside this area
9.
Confirm the position of the tool and press the [ENTER] key.
The plotter will automatically detect the registration mark and cut the cross.
With this function, cutting is performed after sensing the register mark pattern.
If you use a cutter as a tool, be careful not to damage the plotter.
Following error is displayed when the registration mark was not scanned properly.
Press the [RETRY] to scan again, or the [CANCEL] to exit.
Supplement
10.
Confirm the cutting result.
See "Adjust for the registration mark scan position" and adjust if the cutting position is shifted.
See " Automatically adjust the registration mark sensor level" above and make adjustments if you are
unable to scan the registration marks.
To Next Page
Loading...
