GRAPHTEC CE8000 Series - Rear View: CE8000-60

1-7
Rear view: CE8000-60
Power switch
AC line inlet
Accessory case
Media stocker
Stopper
Stopper
Stock shaft
Stand
Media sensor
USB memory dedicated connector
Wired LAN interface
USB interface connector
Wireless LAN module
connection terminal
Power switch .............................Used to turn the plotter on and off.
AC line inlet ...............................Inlet where the power cable is connected.
Media stocker ............................A stock to set roll media in.
Stock shaft ................................. A roller that takes in roll media.
Stopper ......................................Keeps set roll media in place.
Stand .........................................A stand to put the machine on.
Accessory case ........................Space for temporary storage of accessories such as cutter blades and cutter
plungers.
* The accessory case has a magnet. Please attach it in a convenient location.
Media sensor .............................Used to scan the trailing edge of the media.
USB interface connector ...........Used to connect the plotter to the computer with a USB interface cable.
Wireless LAN module connection terminal
.............................................This is the terminal for connecting the wireless LAN module to the plotter.
* A cover is attached to protect the terminals at the time of purchase.
Wired LAN interface ..................This connector is used when connecting this plotter via network (wired LAN).
* Wired LAN unit is factory-installed option.
USB memory dedicated connector
.............................................USB memory dedicated connector.