2-25
2.5
About the Default Screen
The Initial Setup Screen appears only when powering up the machine for the first time after purchase. Here, you
can set the “Display language”, “LENGTH UNIT” and “Wireless LAN”.
Also, after setup, you can select the menu even from the READY status.
See "2.6 Connecting to the Power" for turning on the power.
Operation
1.
Once the machine is powered on (with the " | " switch) a message will be displayed after the firmware
version is displayed.
2.
Press the language you want to use.
3.
Press the unit you want to use.
4.
Select whether to make the wireless LAN settings.
Press [YES] to proceed to the access point setting.
For information on how to set up wireless LAN, see "9.2 Connecting via wireless LAN".
Press [NO] to go to the HOME screen.
This screen will not be displayed if wireless LAN module is not installed.
Supplement
5.
Once the settings are confirmed, the HOME screen will be displayed.
To Next Page
Loading...
