GRAPHTEC CE8000 Series - Setting Length of the Page

4-5
5. Specify the setting value using the [ ] [ ] icon or the [ ] icon.
•
If the settings value is set to other than OFF (0.0 mm), transfer direction of the cutting area will also expand 5
mm forward.
•
You can set the range between 1.0 mm and 10.0 mm, or OFF (0.0 mm).
Supplement
6. Confirm the setting and press the [OK].
7. Press the [ ] icon.
It will return to HOME screen.
Setting length of the page
Set the length of one page when using roll media.
If the cut data is longer than the set page length, only the part that fits within the set page length will be cut, and
the part that exceeds it will not be cut.
•
Default setting for page length is 2 m for CE8000-40, and 5 m for CE8000-60/130.
Check the setting of the page length when cutting long length.
* Please be sure to use the basket (option) when cutting something over 2 m for CE8000-60/CE8000-130.
•
Page ejection quality assurance goes up to 2 m for the CE8000-40 and up to 5m for the CE8000-60/130.
(It depends on the media specified by Graphtec and setting conditions.)
– Use the basket (option).
– Use 3M Scotchcal Series 7725.
– Set the speed below 30 and the acceleration below 2.
– Perform pre feed for the amount to be used before cutting.
– Leave the media in environment to use for adequate time if the deviation of temperature and humidity is big.
– Set the both push rollers at least 15mm inside the edge of media.
•
Set the sideway tension of the media uniform when setting the media when cutting long length.
Media might come off the rollers while cutting if it is not uniform.
•
Pull out the amount to use before cutting when you are using the roll media.
•
To reduce the shifting of the media, perform the pre feed to the full length to be cut.
(see "Pre Feed of Media (Paper or Marking Film)")
Also, pre feeding can be done automatically when the data is received.
(See "Perform Automatic Pre Feed When Cut Data is Received").
* Pre feeding will stabilize the feed by acclimating the media, taking out the slack.
•
This setting will be saved even if the power is shut off.
Supplement
Operation
1. Press the [ ] icon.