15-22
15.6
Confirm the Plotting Data
Output of the dump list of the cutting data received by the plotter is possible. It is used to check if the transmission
of cutting data is performed correctly.
If the command setting is "Auto", the dump list of the cutting data is not output.
Please set the command to "GP-GL" or "HP-GL".
Supplement
Operation
1.
Load a media larger than A4 size.
2.
Set the pen tool to the tool holder (Backward) and select the condition where the pen tool is set.
3.
Press the [ ] icon.
4.
Press the [INFO].
5.
Press the [ ] icon twice.
6.
Press the [DATA DUMP].
7.
Press the [START].
8.
Send the cutting data.
Do not place you hand around the moving areas. The tool carriage will start moving, so there is a chance of
injury.
To Next Page
Loading...
