GRAPHTEC CE8000 Series - Preparation of Cutter Plunger; Cutter Plunger Nomenclature; Structure of Cutter Plunger

2-2
2.1 Preparation of Cutter Plunger
This section describes the structures and types of the cutter plungers (cutter pens).
Cutter plunger nomenclature
The plotter cuts using a cutter blade mounted in a plunger. There are two different plungers to suit the diameter
of the cutter blade to be mounted (the φ0.9 mm cutter plunger is provided as a standard accessory). Be sure to
mount the cutter blade in the corresponding cutter plunger.
PHP33-CB09N-HS/PHP33-CB15N-HS
Cutter blade Plunger
Blade-length adjustment knob
Color ring
(Blue: For φ0.9 mm-diameter blades)
(Red: For φ1.5 mm-diameter blades)
To avoid bodily injury, handle cutter blades with care.
CAUTION
Structure of cutter plunger
PHP33-CB09N-HS/PHP33-CB15N-HS
Cutter blade
φ0.9 mm / φ1.5 mm diameter
Plunger
Plunger-cap
Blade-length
adjustment knob
Hole
Color ring
PHP33-CB09N-HS: Blue
PHP33-CB15N-HS: Red
Please fully insert the cutter blade straight into the plunger cap.
If the cutter blade cannot be inserted straight, please insert the cutter blade after pressing the insertion port of the
cutter blade several times. If not installed correctly, it may result in damage to the cutter blade or the plotter itself.
Insertion port of the cutter blade
CAUTION