2-1
Chapter 2: Preparing to Cut
This chapter describes how to prepare to start the cutting.
SECTION IN THIS CHAPTER
2.1 Preparation of Cutter Plunger
2.2 Attaching a Tool
2.3 Loading Media (Paper or Marking Film)
2.4 Aligning the Push Rollers
2.5 About the Default Screen
2.6 Connecting to the Power
2.7 How to Use Control Panel
2.8 Setting Feeding Method
2.9 Pre Feed of Media (Paper or Marking Film)
2.10 Selecting Tool Condition
2.11 Running Cutting Tests
2.12 Displaying Cutting Area
To Next Page
Loading...
