2-41
5.
Specify the setting value using the [ ] [ ] icon or the [ ] icon.
•
What is Offset
It will adjust the difference between the tip of the blade in the plunger and the center of the plunger. There
are standard adjustment values for each cutter blades. Fine adjustment will be made to those standard
values here. (Adjustment will be made with standard value as 0.)
It is not necessary to set the offset if "PEN", was selected in the tool settings. (not displayed)
•
Guideline to Set Offset
See the Cutter Blade Manual
•
The range that can be set with the tool other than [OTHER] is [-5] to [+5].
The range that can be set in [OTHER] is [+1] to [+45].
Supplement
6.
Confirm the setting and press the [OK].
7.
Press the [ ] icon.
It will return to HOME screen.
Setting the speed
This section explains how to set the speed to be used.
Operation
1.
Press the [ ] icon.
2.
Press the [EDIT CUT CONDITION].
3.
Press the [ ] icon.
4.
Press the tool condition number (1 to 8) you want to set.
To Next Page
Loading...
